![](/images/new-backgrounds/1209155/20915537x1.webp)
All rights reserved | Saw V1.4.doc |
Copyright ♥ Siemens AG 2008 | Manual SIMOTION Flying |
| Section A: Prerequisites and objectives |
| Structure and function |
Flying Saw with SIMOTION |
Table
Physical quantity | Description |
DistanceToSensor | Distance (clearance) between the axis zero of the "flying saw" |
[mm] | and the sensor to sense the material and print mark |
|
|
StartPos | Starting position of the cutting unit referred to the axis zero |
[mm] | point of the "flying saw". |
|
|
SyncPos | Position where the cutting unit reaches the specified material |
[mm] | position and material velocity. Starting point of the |
| synchronous range |
|
|
EndSyncPos | End point of the synchronous range. If, at this particular |
[mm] | position, sawing/cutting has still not been completed, then it is |
| now interrupted. |
|
|
EndPos | End point (end position) of the traversing range of the "flying |
[mm] | saw" |
| (software limit switch) |
|
|
ToStartposVelocity | Velocity for travel to the starting position |
[mm/s] |
|
ToBackposVelocity | Velocity with which the flying saw returns to its starting position |
[mm/s] |
|
|
|
GapLength | Length of the gap after the cutting unit has made a cut. This |
[mm] | gap is to be additionally created between the cut material and |
| the material web. |
|
|
GapVelocity | Superimposed velocity with which the gap is to be created |
[mm/s] |
|
|
|
GearingRatio | Ratio between measured and effective velocity of the material |
| web. |
AccelerationCut | Acceleration value for synchronization motion |
[mm/s²] |
|
|
|
AccelerationBack | Acceleration value for positioning motion back to the starting |
[mm/s²] | position |
AccelerationGap | Acceleration value for the |
[mm/s²] | "gap" |
|
|
Synchronous range
The synchronous range is located between SyncPos and the
EndSyncPos. The material is cut within this range.
V 1.4 | Release 06/06/08 | 19/107 |