All rights reserved | Saw V1.4.doc |
Copyright ♥ Siemens AG 2008 | Manual SIMOTION Flying |
Section D: Program description
Description of important program elements
Flying Saw with SIMOTION |
Step | Function | Comment |
1_enableGearing() is called to synchronize the flying saw axis to the material web at the master and slave positions
If synchronization was successful, then continue with step 3,
if not, then continue with step 2
2_disableGearing() is called to delete (clear) the command from the command queue.
If this is successful, then continue with step 0
3The "cut" output bit is set
The actual synchronous position is deleted (cleared) from the SyncPosBuffer
4Wait until "StopCutting" signal appears
If the "Gap" signal is present, then continue with step 5 If not, then continue with step 6
5_pos() is called for the flying saw axis using the merge mode "SUPERIMPOSED_MOTION_MERGE" in order to create a gap with the superimposed motion.
When completed, then continue with step 6.
6If the "KnifeOut" signal appears, then _pos() is called for the flying saw axis to return to the starting position.
When completed, then continue with step 1.
Automatic Æ Error | 3 | 0 | |
| Automa- |
| Error |
| tic |
| |
|
|
| |
|
|
|
|
_disableAxis() is called for the flying saw axis
If the axis is disabled, then the “error” mode is activated
Automatic Æ Disable | 3 | 0 | ||
|
| Automa- |
| Error |
|
| tic |
| |
|
|
|
| |
|
|
|
|
|
0 | The stop command is prepared |
|
|
|
|
|
|
|
|
V 1.4 | Release 06/06/08 | 96/107 |
