![](/images/new-backgrounds/1209155/20915539x1.webp)
All rights reserved | Saw V1.4.doc |
Copyright ♥ Siemens AG 2008 | Manual SIMOTION Flying |
Section A: Prerequisites and objectives
Structure and function
Flying Saw with SIMOTION |
3.2Operating states of the "FlyingSaw-FB"
The “FlyingSaw FB” automatically controls the “flying saw” axis to implement the required level of functionality.
This functionality is
This means the user only influences the “flying saw” by specifying the required operating mode with the required parameters.
Fig. 3-2 Operating modes
|
| 4 |
|
|
|
| 4 |
|
|
|
| Manual | ||
|
| Manual | ||
1 |
| 0 | ||
1 |
|
| 0 | |
Disable |
|
|
| Error |
|
| |||
Disable |
|
| Error | |
|
| 2 |
|
|
|
| 2 |
|
|
|
| Startposi- | ||
|
| Startposi- | ||
|
| tion | ||
|
| tion |
3
3 Auto- Auto- matic matic
A differentiation is made between the following operating modes:
•Error (0)
The “FlyingSaw FB” has detected an error and brought the flying saw axis into a safe state. The fault is still available and the user can evaluate it.
The flying saw axis is stopped and is in the “disable” state.
•Disable (1)
The “FlyingSaw FB” is already being used but is in the safety operating state. All of the faults/errors present have been successfully acknowledged.
After a reset, the flying saw axis is in the disabled and stopped state.
•Starting position (2)
The flying saw axis moves to the starting position or is located at the
V 1.4 | Release 06/06/08 | 20/107 |