![](/images/new-backgrounds/1209155/20915543x1.webp)
All rights reserved | Saw V1.4.doc |
Copyright ♥ Siemens AG 2008 | Manual SIMOTION Flying |
Section B: The application example as demonstration system
|
|
St t | d f ti |
Flying Saw with SIMOTION |
Section B: The application example as demonstration
system
Contents
All of the necessary steps to commission the standard “flying saw” application as demonstration system are explained in Section B.
Preparations and parameterizing operations are also explained. Further, you are told how you can use the WinCCflex Pro
Objective
Section B of this document provides the reader with the following
•The prerequisites to use this standard SIMOTION application as demonstration system
•Preparations and parameterizing operations are explained
•Describes the steps necessary when presenting this standard application.
•Provides tips for using this standard application.
Subjects discussed
Chap. | Title | Contents |
5 | Installing the | Safety information and instructions |
| hardware and | Components and their interconnections required for the |
| software | presentation |
|
| Installation of standard SIEMENS software |
|
| Downloading the user program in SIMOTION D435 |
|
| Downloading drive parameters in SINAMICS |
6 | Operator control of | Brief instructions on how to use the demonstration system |
| the application | Detailed operating instructions |
| example |
|
V 1.4 | Release 06/06/08 | 22/107 |