Siemens A4027118-A0414 user manual Parameter Data type Initial value Description, Int

All rights reserved	Saw V1.4.doc
Copyright ♥ Siemens AG 2008	Manual SIMOTION Flying

Section C: Integrating the core “flying saw” functions

Program environment and interfaces

Flying Saw with SIMOTION				A4027118-A0414
	Parameter	Data type	Initial value	Description
	Mode	INT	0	Using Mode, the mode is pre-
				selected that is activated with
				the next positive signal edge at
				the execute input.
	StopCutting	BOOL	False	When this bit is set, the module
				is informed that cutting has
				been completed and a gap can
				be created or the cutting device
				can be withdrawn from the
				material.
	KnifeOut	BOOL	False	When this bit is set, the module
				is signaled that the cutting
				device is no longer in contact
				with the material and the
				cutting device can be returned
				to its starting position.
	Gap	BOOL	False	If this bit is set, after a cut, the
				flying saw generates a gap
				between the cut piece of
				material web and the material
				web using a superimposed
				motion of the cutting device.
	OnTheSpotCut	BOOL	False	When this bit is set, a
				synchronous position is
				immediately generated on the
				material web for the next cut.
	PMGenerationMod	INT	PM_CALCULA	PM_CALCULATED:
	e		TED	The next cut position is defined
				automatically after running one
				cutlength.
				PM_MEASURED:
				The next cut position is defined
				by printmark detection.
	TypeOfSynchronis	INT	BY_TIME	BY_TIME:
	ation			The synchronizing is done
				according to dynamic values
				entered.
				BY_LEADING_AXIS_VALUE:
				The synchronizing is done
				according to leading axis
				values. The master synclength
				is set to a value as twice as
				slave synclength automatically.
				This causes an asymptotic
				synchronization.

V 1.4 Release 06/06/08 67/107