All rights reserved | Saw V1.4.doc |
Copyright ♥ Siemens AG 2008 | Manual SIMOTION Flying |
Section D: Program description
Description of important program elements
Flying Saw with SIMOTION |
Step | Function | Comment |
3_disableGearing() is called to delete (clear) the command from the command queue.
If required, then continue with step 1
4The "cut" output bit is set
The actual synchronous position is deleted (cleared) from the SyncPosBuffer
5Wait until "StopCutting" signal appears
If the "Gap" signal is present, then continue with step 6 If not, then continue with step 7
6_pos() is called for the flying saw axis with the "superimposed" merge mode in order to create a gap with the superimposed motion.
When completed, then continue with step 7.
7If the "KnifeOut" signal appears, then _pos() is called for the flying saw axis to position back to the starting position.
When completed, then continue with step 1.
Starting position Æ Manual |
| 2 |
|
| 4 |
| |
|
|
| Startpo- |
|
| Manual |
|
|
|
| sition |
| |||
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| This state change is achieved using an automatic state |
|
|
|
|
|
|
| change sequence that reaches the manual state through |
|
|
|
|
|
|
| the disable state. |
|
|
|
|
|
|
|
|
|
|
|
| ||
Mode, automatic (3) | 3 |
|
|
| |||
|
|
| Automa- |
|
| ||
|
|
|
| tic |
|
| |
|
|
|
|
|
|
|
|
Automatic cycle
0Wait until a valid synchronous position is available If yes, then advance to step 1
V 1.4 | Release 06/06/08 | 95/107 |
