Sony Ericsson GM48, GM47 manual 12.5 AT+WS46 Mode Selection, ATE Command Echo, Phone

GM47/GM48 INTEGRATOR’S MANUAL

Determines the behaviour of the data set ready signal.

<value>	Description
0	DSR always on
1	DSR on in data mode. DSR off in command mode. Default
	value

12.5 AT+WS46	Mode Selection
	Description		Command	Possible Responses
	Sets the cellular		AT+WS46=n	•	OK
	protocol mode			• ERROR
	Show the current		AT+WS46?	•	<n> OK
	setting			•	ERROR
	Show if the command		AT+WS46=?	• (list of supported <n>s) OK
	is supported			•	ERROR
	Allows an accessory to query and control the cellular protocol mode of
	the phone.
	<n> parameter	Description
	12	This value is used for GSM at 900 Mhz., DCS-1800, and
		PCS-1900 phones
12.6 ATE	Command Echo
	Description		Command		Possible Responses
	Request Command		ATE[<value>]		• OK
	Echo		ATE=[<value>]		• ERROR
	Show the current		ATE?		<value>
	setting
	Show if the command		ATE=?		E: (list of supported
	is supported				<value>s)

The setting of this parameter determines whether or not the DCE echoes characters received from the DTE during command state and online command state.

<value> Description

0DCE does not echo characters during command state and online command state

1DCE echoes characters during command state and online command state. Default value

198

LZT 123 7263 R1C