Sony Ericsson GM48, GM47 manual ATZ Reset to Default Configuration

GM47/GM48 INTEGRATOR’S MANUAL

12.8 ATZ	Reset to Default Configuration
	Description	Command	Possible Responses
	Execute	ATZ	• OK
			• ERROR
	Execute	ATZ=<profile>	• OK
			• ERROR
	Show if supported and	ATZ=?	Z: (list of supported
	list available		<profile>s)
	parameter range

This command instructs the DCE to set all parameters to their default values as specified by the user. Consider hardware configuration switches or non-volatile parameter storage (if implemented) when using this command.

Commands included on the same command line as the Z command will be ignored.

	<profile >	Description
	0	Select the user profile to restore
12.9 AT+CMUX Switch to 07.10 Multiplex Protocol
	Description	Command	Possible Responses
	Switch to 07.10	AT+CMUX=<transpa	+CME ERROR: <err>
		rency>[,<subset>[,
		<port_speed>[,<N1>
		[,<T1>[,<N2>[,<T2>
		[,<T3>[,<k>]]]]]]]]
	Show the current	AT+CMUX?	•	+CMUX:<transparency>,
	setting			<subset>,<port_speed>,<N1>
				,<T1>,<N2>,<T2>,<T3>[,<k>]
			•	+CME ERROR: <err>
	Show if the	AT+CMUX=?	• +CMUX: (list of supported
	command is			<transparency>s),
	supported			(list of supported <subset>s),
				(list of supported
				<port_speed>s),
				(list of supported <N1>s),
				(list of supported <T1>s),
				(list of supported <N2>s),
				(list of supported <T2>s),
				(list of supported <T3>s),
				(list of supported <k>)
			•	+CME ERROR: <err>

The command is used to turn on the multiplexer. Only “no transparency is supported”. The parameter <k> is not used.

200

LZT 123 7263 R1C