Sony Ericsson GM47, GM48 manual Test

2. USING THE DEVELOPER’S KIT

Connector	Description	Connections
J10	SYSTEM	For optional flat cable connection between
	connector	the module and the development board
		(see Figure 2.3, page 31)
J11	TEST	60 pin, 2.54mm pitch, dual row pin header
	connector	that carries all signals present at the system
		connector of the module. Used for easy
		testing of the signals (see Figure 2.4,
		page 36)
J12	Application	For flat cable connection between a host
	connector	application and the module. Most of the
		signals pass through jumpers that allow the
		developer to select whether a specific
		signal is routed to/from the development
		board or to/from the host application. If no
		application is connected to J12, these
		jumpers (SW1, SW3, SW5, SW6, SW7, SW8,
		SW9, SW10 & SW11) serve as on/off switches
		for the module signals (see Figure 2.3,
		page 31)
12v	2.1mm DC	Allows connection of an
	Power Socket	external power supply.
		Between 10V and 15V d.c. at
		6 watts is required
RF	SMA panel	Connect the supplied antenna
	socket

35

LZT 123 7263 R1C