Sony Ericsson GM47, GM48 12.16 AT*E2ESC M2M Escape Sequence Guard Time, AT*E2ESC?, AT*E2ESC=?

12. INTERFACE

<InitSync>	Description
0	Sync Pin initial state LOW
1	Sync Pin initial state HIGH
<byte x>,	Description
<byte x rx>
0-255	decimal value denoting the byte value to be sent
<active>	Description
0	SPI bus is active (pins are controlled by SPI)
1	SPI bus is not active (pins are not controlled by SPI)

12.16 AT*E2ESC M2M Escape Sequence Guard Time

Description	Command	Possible responses
Set GPRS online	AT*E2ESC=[<gt>]	• OK
command guard time		• ERROR
Show the current	AT*E2ESC?	*E2ESC: <gt>
setting
Show if the command	AT*E2ESC=?	• OK
is supported		• ERROR

Defines a guard time for the escape sequence in GPRS to return to on- line command mode i.e. if +++AT<CR> is received either as part of the data stream or a terminating string from the application and no further data is received for the duration of the guard time the module will go into on line command mode. This guards against the module accidentally going into on line command mode. The verbose format of

+++AT<CR> is <S2><S2><S2>AT<S3>.

<gt>	Description
0	No guard time. Default value
1-10	Guard time in seconds

207

LZT 123 7263 R1C