Sun Microsystems SL8500 manual Moving the Robot, To locate a cartridge, To locate a drive

Manual Mode of Operation

▼To locate a cartridge

1.Logon to the StreamLine Library Console.

2.Select Tools > Utilities and then select the Search tab.

3.From the pull-down menu select Cartridge Location as the Search Type.

4.Enter the VOLID of the cartridge you are trying to locate.

5.Select the Requester (see notes below) as the default from the pull-down menu.

6.Select the Cartridge Type (data, clean, unreadable label, duplicate label).

7.Select Search button from the top right corner.

See FIGURE A-1 on page 111 through FIGURE 0-1 on page 118 for pictorial maps of the cartridge locations.

Notes:

■You can lookup a cartridge location either in the internal library firmware format or the HLI-PRC format based on the library management software (see “Internal Address” on page 110 and “HLI-PRC Address” on page 122 ).

■If the library is in a complex, make sure you enter the correct library number (for the internal firmware address search) or the LSM number (for the HLI-PRC address search). For more information see “PTP Addressing Scheme” on page 34.

▼To locate a drive

See “Manually Locating a Drive Bay” on page 128.

Moving the Robot

You might have to move the robot to:

■Locate the cartridge from the slots.

■Access the drive panel and identify the drive to perform a manual mount/dismount.

Warning – Possible Physical Injury. To prevent physical injury and damage to components, follow the instructions carefully.

▼To move the robot, follow these precautions:

1.Do not enter the library or move any of the HandBot mechanisms if you have any reason to suspect they are enabled.

2.Do not touch any shiny polished surfaces. Body oils can destroy the lubrication on these surfaces.

96154 • Revision K Chapter 4 Library Operation 63