Symmetricom 1000, 1100 manual Tables

		Table of Contents
Tables
1-1	Typical Power Consumption	. . . . . . . . 33
1-2	SSU-Based Reference Selection Scenarios	. . . . . . . . 37
1-3	Subtending-Based Reference Selection Scenarios	. . . . . . . . 37
1-4	ANSI SSM Quality Level Definitions	. . . . . . . . 41
1-5	ITU SSM Quality Level Definitions	. . . . . . . . 42
2-1	Input Modules Available for the TimeProvider	. . . . . . . .47
2-2	Output Modules and Accessories Available for the TimeProvider . .	. . . . . . . . 47
2-3	IOC and IMC Modules Available for the TimeProvider	. . . . . . . . 48
2-4	GPS Parts and Accessories	. . . . . . . . 49
2-5	TimeProvider Shelves	. . . . . . . . 51
3-1	Power Connections	. . . . . . . . 61
3-2	Input Connector Modules Available for the IOC	. . . . . . . . 63
3-3	Pinout for the DB9 Input Module	. . . . . . . .64
3-4	Output Connector Modules	. . . . . . . . 66
3-5	Pinout for the DB9 Output Module	. . . . . . . . 66
3-6	Alarm Connector Pinout	. . . . . . . . 70
3-7	Connector Pinouts for the Serial Ports	. . . . . . . . 79
3-8	Ethernet Communications Port Signal Connections	. . . . . . . . 81
3-9	Installation Completeness Checklist	. . . . . . . . 82
3-10	Firmware Feature Matrix	. . . . . . . . 84
4-1	TL1 Syntax Conventions	. . . . . . . . 86
4-2	Default Mask Parameters	. . . . . . . 117
4-3	Alarm Conditions and Defaults	. . . . . . . 127
4-4	Provisioning Record	. . . . . . . 141
5-1	LED Conditions for the IOC	. . . . . . . 146
5-2	LED Conditions for the IMC and IMC/TPIU	. . . . . . . 147
5-3	Record of Test Results	. . . . . . . 153
6-1	Preventive Maintenance	. . . . . . . 156
6-2	LED Conditions for the IOC	. . . . . . . 157
6-3	LED Conditions for the IMC and IMC/TPIU	. . . . . . . 162
6-4	LED Conditions for the External TPIU	. . . . . . . 164
6-5	Event Codes	. . . . . . . 167
6-6	Set and Clear Conditions for Alarms	. . . . . . . 174
6-7	Alarm Codes	. . . . . . . 176
6-8	Conditions Causing an Event	. . . . . . . 184
7-1	Serial Port Specifications	. . . . . . . 194
7-2	Holdover Characteristics	. . . . . . . 195
7-3	Hold-in and Pull-in Range	. . . . . . . 196
7-4	Input Signal Specifications	. . . . . . . 197
7-5	Output Signal Specifications	. . . . . . . 198
7-6	Output Alarm Specifications	. . . . . . . 200

097-58001-02 Revision G – April 2008 TimeProvider User’s Guide 11