Symmetricom 1100, 1000 manual Setting the Handshaking Flow Mode, Setting the Echo Mode

Chapter 4 Provisioning the TimeProvider

Setting Communications Parameters

Setting the Handshaking (Flow) Mode

Use the ED-EQPT command to provision the handshaking mode on the local Craft or Remote port to None, Hardware, Software, or Hardware/Software.

ED-EQPT:[<tid>]:<aid>:[<ctag>]::<keyword>=<value>;

This command has a default access level of ADMIN.

<aid>	<keyword>	<value>	Description	Default value
COMp	FLOW	NONE SW	Flow control	NONE
p = L R		HW SWHW

Sample Command

ED-EQPT::COML:TS1000::FLOW=HW;

Normal Response

TIMEPROVIDER 03-10-24 10:12:33

MTS1000 COMPLD

;

Setting the Echo Mode

Use the ED-EQPT command to provision the echo mode on the local Craft or Remote port to On or Off. When set to ENABLE, characters you type at the keyboard also appear on the monitor. If one keystroke generates two characters on the monitor, set this parameter to DISABLE.

You can also use ED-EQPT to echo the <tid> in the response from the TimeProvider.

ED-EQPT:[<tid>]:<aid>:[<ctag>]::<keyword>[=<value>];

This command has a default access level of ADMIN.

<aid>	<keyword>	<value>	Description	Default value
COMp	ECHO	ENABLE DISABLE	Input echo	DISABLE
p = L R
	TIDQUIET	ENABLE DISABLE	Enables or disables the	DISABLE
			echo of the <tid>. This
			is a session setting.

Sample Command

ED-EQPT::COML:TS1000::ECHO=ENABLE;

Normal Response

TIMEPROVIDER 03-10-24 10:15:04

MTS1000 COMPLD

;

92 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008