Symmetricom 1000, 1100 manual Eqpt Squelch, Gpsclr, Del, Ssm, Loctim, Eqpt Auto, Timchg

Chapter 6 Maintaining and Troubleshooting the TimeProvider

Troubleshooting the TimeProvider

Table 6-5. Event Codes (Continued)

Event ID	Keyword	AID	Default Value/	Description of Values
	Description	TYPE	Keyword
FREEFLT	Indicates if the Output	EQPT	SQUELCH	ON – In fault mode, generate
	Fault is issued when			outputs based on system SSM
	the local oscillator			AIS – In fault mode, generate
	enters Free-Run			AIS outputs
	mode.			SQUELCH – In fault mode,
				outputs are turned off
GPSCLR	The time, in seconds,	EQPT	5 s	0 to 1000 s
DEL	after a cleared GPS
	fault can be used.
GPSFLTDEL	Time, in seconds,	EQPT	1 second	1 to 1000 s
	before a GPS fault
	indicated it is not valid
HOLDFLT	Indicates if the Output	EQPT	ON	ON – In fault mode, generate
	Fault is issued when			outputs based on system
	the local oscillator			SSM
	enters Holdover mode			AIS – In fault mode, generate
				AIS outputs
				SQUELCH – In fault mode,
				outputs are turned off
INPREF	Indicates if the system	T1	PRS	PRS – PRS input is selected
	automatically selects			as reference
	another reference			INP1 – INP1 is selected as
	input. Operator has			reference
	enabled the selected			INP2 – INP2 is selected as
	reference input			reference
	(REFMODE must be
	set to FORCED)
LOCTIM	The local system time	EQPT	(00)-00	(hh) – hours offset ±12
	offset has changed			mm – minutes offset 00 to 59
REFMODE	Indicates if the system	EQPT	AUTO	AUTO – System uses
	reference can be			QLEVEL and Priority to select
	selected automatically			the system reference
	or by the user			FORCED – User selects the
				system reference. If the
				selected reference fails, this
				value reverts to AUTO mode
TIMCHG	The system time has	EQPT	hh-mm-ss	hh – hours (24-hour clock)
	been changed			mm – minutes
				ss – seconds

097-58001-02 Revision G – April 2008 TimeProvider User’s Guide 173