Symmetricom 1100, 1000 manual Restarting the TimeProvider, SYS Factory, IMC Reset

Chapter 4 Provisioning the TimeProvider

System Commands

Normal Response Format

<cr><lf><lf>

^^^sid^date^time<cr><lf>

M^ctag^COMPLD<cr><lf>

^^^”<aid>:<keyword>,<value>”<cr><lf>

;

Restarting the TimeProvider

Use the INIT-SYS command to reset the specified module or to clear all information stored in non-volatile memory. All users logged in to the TimeProvider are logged out and the user list is cleared.

Caution: This command causes the local oscillator in the specified IOC to enter the Warm-up mode; the outputs remain in the holdover mode until the local oscillator locks on to the input reference signal.

All SYS parameters are reset, including the entire user list. You must create a new security-level user after issuing this command with the SYS:FACTORY aid and keyword.

INIT-SYS:[<tid>]:<aid>:[<ctag>]::<keyword>;

This command has a default access level of ADMIN.

<aid>	<keyword>	Description
SYS	FACTORY	Resets the SID, security, communication ports, and
		alarm settings to factory defaults (see Appendix A,
		Factory Default Values)
IMC	RESET	Performs a soft reset on the card and clears all alarms.
IOCm		Does not affect the SID, security, communication
m = 1 2		ports, and alarm settings

Sample Command

INIT-SYS::IOC1:::RESET;

Autonomous Message

TP-SSU 03-10-24 11:31:52 A 1193 REPT EVT

“IOC,EQPT:MN,RESET,NSA,03-10-24 11-30-42:\”MODULE HAS BEEN RESET\””

;

140 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008