Symmetricom 1100, 1000 manual Using Alarm Codes to Troubleshoot

Chapter 6 Maintaining and Troubleshooting the TimeProvider

Troubleshooting the TimeProvider

Table 6-6. Set and Clear Conditions for Alarms (Continued)

Alarm ID	Set Alarm Conditional Description	Clear Alarm Conditional Description
INPTRR	Tip/ring reversal on CC input	Tip/ring connection correct on CC input
EXDSC	Excessive discontinuity fault	Excessive discontinuity cleared
MTIE	MTIE exceeded threshold	MTIE within threshold
	OUT[g] Codes
OUTFAIL	Output fault	Output fault cleared
SYNTHEOR	Output generator exceeds pull-in range	Output generator within pull-in range
SYNTHFAIL	Output generator failed	Output generator restored
	E422[g] Codes
E422EQPT	EIA-422 Output module is unequipped	EIA-422 Output module is equipped
E422FAULT	EIA-422 Output module has a fault	EIA-422 Output module fault cleared
	RTMg[-p] Codes
RTMEQPT	Retimer module is unequipped	Retimer module is equipped
S1LOS	Side 1 LOS fault	Side 1 LOS fault cleared
S2LOS	Side 2 LOS fault	Side 2 LOS fault cleared
EXSLIP	Slip rate threshold exceeded	Slip rate within threshold
RTMFAULT	Retimer module has a fault	Retimer module fault cleared

Using Alarm Codes to Troubleshoot

Table 6-7lists the alarm codes generated by the TimeProvider. Unless specified, each alarm has a default Error Delay of Immediate, and you cannot edit the Error Delay.

Table 6-7. Alarm Codes

			AID	Service		Alarm Level
Event ID	Description
			TYPE	Affecting	SSU		PRR	SUB
					Mode		Mode	Mode
		AID = SYS
COMPAT	System components (hardware		EQPT	NSA	MJ		MJ	MJ
	or software) are incompatible.

176 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008