Symmetricom 1100, 1000 manual Unpacking the Unit, Rack Mounting, Main Shelf

Chapter 3 Installing the TimeProvider

Unpacking the Unit

Unpacking the Unit

The TimeProvider and accessories are packaged to protect from normal shock, vibration, and handling damage.

Caution: To avoid electrostatic discharge (ESD) damage to parts that are packaged with the TimeProvider, observe the following procedures.

Unpack and inspect the unit as follows:

1.Wear a properly grounded protective wrist strap or other ESD device.

2.Inspect the container for signs of damage. If the container appears to be damaged, notify both the carrier and your Symmetricom distributor. Retain the shipping container and packing material for the carrier to inspect.

3.Open the container, being careful to cut only the packaging tape.

4.Locate and set aside the printed information and paperwork that is included in the container.

5.Remove the unit from the container and place it on an anti-static surface.

6.Locate and set aside small parts which may be packed in the container.

7.Remove the accessories from the container.

8.Remove the anti-static packaging from the unit and accessories.

9.Verify that the model and item number shown on the shipping list agrees with the model and item number on the equipment. The item number can be found on a label affixed to the TimeProvider. Contact your Symmetricom distributor if the model or item number do not match.

For a complete listing of TimeProvider item numbers and configuration options, contact your Symmetricom distributor.

Rack Mounting

The installation procedure described in this section provides general guidelines for installing the shelf and the optional Expansion panel and Cable Management tray. Always follow applicable local electrical codes.

Main Shelf

The main shelf (Model 1000 and 1100) mounts to either a 19-inch or 23-inch rack using reversible mounting ears.

56 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008