Symmetricom 1100, 1000 manual Making Output Connections, Installing the Output Module

Chapter 3 Installing the TimeProvider

Making Connections

Making Output Connections

You make the output signal connections using one of the Output modules listed in Table 3-4. Attach the module to the shelf before you connect cables.

Table 3-4. Output Connector Modules

Item Number	Description	Reference
090-58091-01	BNC Output module	Figure 3-12
090-58091-02	Wire-wrap Output module	Figure 3-12
090-58091-03	DB9 Output module – four connectors	Figure 3-13
090-58091-07	DB9 Output module – eight connectors	Figure 3-13
090-58091-04	SMZ/BT43 Output module	Figure 3-14
090-58091-05	Metric (Siemens) 1.0/2.3 Output module	Figure 3-14
090-58091-06	Metric (Siemens) 1.6/5.6 Output module	Figure 3-14
090-58071-02	Wire-wrap TIA/EIA-B-422 Output module	Figure 3-15

Installing the Output Module

Attach the Output module to the shelf and secure it using the screws at the top and bottom of the module.

Table 3-5lists the pinout for the DB9 four-connector Output module (090-58091-03), and the DB9 eight-connector Output module (090-58091-07) which are shown in Figure 3-13.

Table 3-5. Pinout for the DB9 Output Module

4-Connector Output Module		8-Connector Output Module
Pin	Description	Pin	Description
1	Port A Tip	1	Chassis Ground
2	Port A Ring	2	Tip (or Ring)
4, 5, and 6	Chassis Ground	6	Ring (or Tip)
8	Port B Tip	3, 4, 5	Not used
9	Port B Ring	7, 8, 9	Not used

66 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008