Teledyne manual 1 6712 Remote Menu Commands, 6712FR Refrigerated Sampler, Remote Operation

		6712FR Refrigerated Sampler
		Section 7 Remote Operation
	Table 7-1 6712 Remote Menu Commands
Menu Command	Description
0 or START	This command will immediately start any program set to WAIT FOR PHONE CALL and cur-
	rently waiting for the remote start command (see Section 4.6).
1 or RUN1	This command will load Program 1 as the sampler’s current Extended program, reset partition if
	the storage interval has been changed, and run the program. RUN1 is valid when the sampler
	is in standby, or when it is waiting for a start command. RUN1 will also run the current program
	while in Standard programming.
2 or RUN2	These commands will load the selected program number as the sampler’s current Extended
3 or RUN3	program, reset partition data if the storage interval has changed, and run the program. They are
	valid when the sampler is in standby, or when it is waiting for a start command. The commands
4 or RUN4	are available for Extended programming only.
5 or DISABLE	This command is similar in functionality to a pin F low signal (a signal typically used to enable or
	disable the sampler from a flow meter). At run time, the sampler starts with the sampler in the
	enabled state. DISABLE is valid while a program is running. If successful, a display of REMOTE
	ENABLE IS FALSE will be returned.
	A Remote Disable is the highest priority disable. If the sampler is disabled with this command,
	no condition other than menu command 6, ENABLE, will allow the program to become enabled
	again.
6 or ENABLE	This command is used to re-enable a disabled sampler. ENABLE is valid while a program is
	running. If successful, a display of REMOTE ENABLE IS TRUE will be returned.
7 or TAKE_SAMPLE	This command causes the sampler currently running a program to take a sample. The sample
	will count as one of the program’s samples and is placed in the current bottle (Part A’s current
	bottle when using two-part programming). TAKE_SAMPLE is valid while the program is run-
	ning, after the start time, but not while in the MANUAL PAUSE screens. If successful, a
	response similar to PUMPING XXML SAMPLE INTO BOTTLE ## will be returned. If not, a
	response similar to NO SAMPLE, PROGRAM WAITING START will be returned.
ST or STATUS	This command causes the sampler to return its status information and current parameter data.
SD or	This command causes the sampler to return the information currently displayed on the sam-
SCREEN_DUMP	pler’s screen. The remote screen follows the sampler’s display as the information is updated.
	This mode can be used to observe from a remote location while the sampler is programmed
	on-site.
P or PAUSE	This command causes a sampler currently running a program to enter the MANUAL PAUSE
	menu. While you are connected in this mode, the sampler keypad becomes disabled, and your
	computer’s keypad will be redirected to simulate the sampler keypad. The following keys will be
	activated:
	<Enter>, decimal point, and number keys.
	<Esc>, S, or s = STOP.
	<Backspace>, L or l, and U or u = Left/Up arrows.
	R or r, and D or d = Right/Down arrows.
Sampling reports		You can retrieve the sampling reports at any time using the same
		serial connection. Type “Q” to exit the menu. Then at the >
		prompt, type “REPORT” and press Enter. The sampler controller
		will send reports as configured.

7-3