Teledyne GFC 7001EM operation manual Current Loop Option Installed on the Motherboard

Optional Hardware and Software Model GFC7001E Carbon Dioxide Analyzer

Figure 5-2: Current Loop Option Installed on the Motherboard

5.4.1.CONVERTING CURRENT LOOP ANALOG OUTPUTS TO STANDARD VOLTAGE OUTPUTS

NOTE

Servicing or handling of circuit components requires electrostatic discharge protection, i.e. ESD grounding straps, mats and containers. Failure to use ESD protection when working with electronic assemblies will void the instrument warranty.

See Section 14 for more information on preventing ESD damage.

To convert an output configured for current loop operation to the standard 0 to 5 VDC output operation:

1.Turn off power to the analyzer.

2.If a recording device was connected to the output being modified, disconnect it.

3.Remove the top cover.

Remove the screw located in the top, center of the front panel.

Remove the screws on both sides that fasten the top cover to the unit.

Slide the cover back and lift straight up.

4.Remove the screw holding the current loop option to the motherboard.

Teledyne Analytical Instruments 63