Toshiba DKT2520-FS, DKT2510-FSD manual Remote Destination Change, To change the destination number

Features Call Forward

Remote Destination Change

If Call Forward-External mode is set at your station, you can change the forwarding destination from a telephone outside of the system.

➤ To change the destination number

1. Call into the CT system over	You hear ringback tone signal, then internal dial tone for 10
an Exchange line	seconds.
programmed for the DISA	Try again if you hear busy tone.
feature.
	Note See the System Administrator for DISA telephone
	numbers.
2. After you receive dial tone,	You hear a confirmation tone.
press #670 then dial your	If a number is not dialled, the system automatically makes the
[PDN].
	DISA Exchange line ring as a normal incoming call. Then, if
	the call is not answered within 15 seconds after the ringing
	starts, it disconnects.
3. Enter the Remote Call	You hear a confirmation tone. See the System Administrator for
Forward-External security	the security code which is assigned to your telephone in system
code.	programming.

4.Enter the new destination number. You can enter an internal number, Voice Mail number or, an Exchange line access code plus an external telephone number. With some systems, you can dial a line group code instead of an Exchange line number access code. (Table 14 on Page 156 for access code information.)

5. Press #. You hear a confirmation tone.

Strata CT Digital Telephone User Guide November 2001 33