Toshiba DKT2510-FSD Message Waiting Light on PDN, To answer a Msg light, To cancel the Msg light

Message Waiting Features

Message Waiting Light on [PDN]

➤To answer a Msg light

1.Press Msg, then lift the handset.

If you reach a station that is

busy or does not answer, go on-hook and press Msg again.

The system rotates to the next message sender.

The LCD can show up to three stations that have left messages for the [PDN] and three for each of your [PhDNs].

2.Press Scroll to display them.

3.After receiving the message(s), place the handset on hook.

➤To cancel the Msg light

Your phone rings the station or voice mail device that set the indication. The LED continues to flash red.

In the example (shown at	NO. 204
right), the display indicates
	CALL 203-201+
that station DN [203] received
a message signal from DN [201].

The “+” indicates additional messages.

If the Msg LED continues to flash, you have more messages–repeat the Steps to retrieve them. Voice mail devices may cancel the indication after a short delay.

➤Press Msg and lift the handset.

...or [DN] + #409 to cancel the light. This must be done for each message recorded.

Your Msg LED turns OFF when the called party answers.

Note The called party must answer–by either going

off-hook or by pressing Spkr–for the indication to be cancelled automatically.

Your Msg LED turns OFF without calling the telephone or VM device.

52 Strata CT Digital Telephone User Guide November 2001