Toshiba DKT2510-FSD, DKT2520-FSD manual 125, To change the destination number

Single Line Digital Telephone Features Call Forward (CF)

➤To change the destination number

1.	Call into the Strata CT system over an	You hear ring back tone signal, then internal dial tone
	Exchange line programmed for the DISA	for 10 seconds. Try again if you hear busy tone.
	feature.	Note See the System Administrator for DISA
		telephone numbers.
2.	After you hear dial tone, press #670,	You hear a confirmation tone.
	then enter a [PDN].	If a number is not dialled, the system automatically
		causes the DISA Exchange line to ring at telephones as
		a normal incoming call. Then, if the call is not
		answered within 15 seconds after the ringing starts, it
		disconnects.
3.	Enter the Remote Call Forward-External	You hear a confirmation tone. See the System
	security code.	Administrator for the access code.

4.Enter the new destination number.

You can enter an internal [PDN], or an Exchange or Tie line access code + an external telephone number.

With some systems, you can dial a line group code instead of an Exchange line number access code (see Table 14 on page 156).

You cannot enter the LCR access code 9.

Important!	Do not press #, since
	that ends the
	procedure (see Step 5).
	Instead, use 44 when
	entering an Exchange
	line access code.
5. Press #.	You hear a confirmation tone.

Strata CT Digital Telephone User Guide November 2001 125