4.13 MDC/USB board4 Replacement Procedures
USB model
1. Remove the following screw securing the USB board.
• M2.5⋅6C | Tapping screw | ⋅1 |
2.Peel off the acetate tape.
3.Disconnect the USB harness from the connector CN9770 on the USB board and connector CN9570 on the system board.
M2.5x6C Tapping
USB board
USB harness | CN9770 (Back of the USB board) |
Acetate tape
CN9570
(Back of the system board)
Figure 4-29 Removing the MDC/USB board (3) (USB model)
TECRA M11/Satellite Pro S500M Series Maintenance Manual |
