4.22 Touch pad/Fingerprint sensor board

4 Replacement Procedures

Installing the Touch pad/Fingerprint sensor board

To install the touch pad/fingerprint sensor board, follow the steps below and refer to Figure 4-46 to 4-50.

1.Stick a new touch pad in place.

2.Set the pad button on the touch pad and secure it with the following screws.

• M2.0⋅3C

S-THIN HEAD screw

⋅2

3.Set the fingerprint sensor board to the touch pad plate and secure them with the following screws.

• M2.0⋅3C

S-THIN HEAD screw

⋅2

NOTE: When replacing the touch pad plate with a new one, stick the gasket and

insulator (TPAD INSULATOR) to the touch pad plate in place.

Touch pad plate

TPAD INSULATOR

Gasket

TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)

[CONFIDENTIAL]

4-89

Page 380
Image 380
Toshiba S500M Installing the Touch pad/Fingerprint sensor board, Insulator Tpad Insulator to the touch pad plate in place