Toshiba S500M manual Replacement Procedures Cover assembly and Base assembly

4 Replacement Procedures 4.12 Cover assembly and Base assembly

Installing the Cover assembly and Base assembly

To install the cover assembly and base assembly, follow the steps below and refer to Figure 4-22 to 4-26.

1.Place the cover assembly on the base assembly and secure them with the following screws.

•	M2.5⋅8B	FLAT HEAD screw	⋅5
•	M2.5⋅12B	FLAT HEAD screw	⋅3

2.Turn up the insulator (LCD CONN INSULATOR) and connect the LCD harness to the connector CN5300 on the system board.

NOTE: Arrange the LCD harness under the guides.

Guide

Guide

Guide

LCD harness

When replacing the cover assembly with a new one, stick the insulator (LCD CONN INSULATOR) to the system board in place.

When sticking the LCD CONN INSULATOR, set the cushion of the LCD CONN INSULATOR on the connector of the LCD harness.

3.Connect the FS board FFC and camera harness to the connector CN9550 and CN9540 on the system board.

4-46 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)