4.12 Cover assembly and Base assembly | 4 Replacement Procedures |
4.12 Cover assembly and Base assembly
Removing the Cover assembly and Base assembly
To remove the cover assembly and base assembly, follow the steps below and refer to Figure
1.Close the display and turn over the computer.
2.Disconnect the 3G antenna cables and 3G power harness from the connectors on the jack/3G/Express board.
3G antenna cable (blue)
3G antenna cable (red)
3G power harness
Figure 4-22 Removing the cover assembly and base assembly (1)
TECRA M11/Satellite Pro S500M Series Maintenance Manual |
