4 Replacement Procedures

4.18 RGB/USB board

Installing the RGB/USB board

To install the RGB/USB board, follow the steps below and refer to Figure 4-36 and 4-37.

1.Connect the USB harness to the connector CN9610 on the RGB/USB board and arrange the harness in place.

2.Set the RGB/USB board to the slot of the base assembly.

3.Set the DC-IN harness to the slot of the base assembly.

4.Secure the RGB/USB board with the following screw.

• M2.5⋅6C Tapping screw ⋅1

5. Connect the RGB harness to the connector CN9611 on the RGB/USB board.

4-66 [CONFIDENTIAL]

TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)

Page 357
Image 357
Toshiba S500M manual Installing the RGB/USB board