4.Place the
Figure 49: Scanner Resting in Charging Cradle
5.The battery pack must be fully charged prior to initial use; this takes approximately 6 hours. While the unit is charging in the cradle, a Charging message appears in display window on the front of the scanner; a Battery Full message displays in the window when the unit is fully charged.
6.Later in this chapter, you use the cradle to upload
Plug the flat prong end of the supplied serial cable into the flat receptacle located on the back of the Charging and Communication cradle.
Plug the serial connector end of the cable into the serial port of the PC from which the software will be loaded.
Once the required software has been uploaded to each scanner unit, this serial connection is not necessary for daily operation of the scanner. You may have to utilize this connection on an occasional basis to load software updates to the scanner units as they are released in the future.
Important Note!!!
Once you have successfully completed upload of the firmware update to each scanner, store the serial cable in a safe location and do not lose it! You will need to use it at a later date for uploading of the firmware update to each scanner when enhanced by Furniture Wizard Software! Refer to the Scanner Kernel and Firmware Update directions found in the Appendix section of this manual for details on how to update each wireless scanner when software updates are released in the future.
Appendix A: Using Wireless Scanners with Furniture Wizard | 57 |
