Xantrex Technology PV100S-208 manual Fpga

Troubleshooting

Table 4-1Fault Codes

Error		Fault Type
		H=Hardware
Code	Fault Source(s)	S=Software	Fault Description	Possible Causes
0075	Shutdown Remotely	S	This fault indicates that the PV100S	•	Remote Shutdown
			has detected that the system was		command via the GUI
			commanded via the GUI to transition
			to the Shutdown State. This fault is
			not indicative of a failure or
			malfunction, but primarily used to
			disable the system remotely.
0082	Matrix Not ON	S	This fault indicates that the PV100S	•	Software acknowledge
			has detected that the IGBT matrix		bit not accepted
			(FPGA) was not enabled after having	•	FPGA inoperable
			sent a command for it to turn on. The
			CCU2 sends an acknowledge bit to
			confirm the command is received.
			This fault is primarily a watch-dog
			between software and hardware to
			ensure control of the IGBT matrix
			(FPGA).
0083	Matrix Not OFF	S	This fault indicates that the PV100S	•	Software acknowledge
			has detected that the IGBT matrix		bit not accepted
			(FPGA) was not disabled after having	•	FPGA inoperable
			sent a command for it to turn off. The
			CCU2 sends an acknowledge bit to
			confirm the command is received.
			This fault is primarily a watch-dog
			between software and hardware to
			ensure control of the IGBT matrix
			(FPGA).
F000	Shipping Software	S	This fault indicates that the PV100S
			has detected that the CCU2 controller
			board has shipping software installed.
			This software is not operational
			software. The correct system
			software for the PV100S must be
			downloaded into the CCU2 controller
			board.
F100	Software Restarted	S	This fault indicates that the PV100S
			has detected that the system software
			has been re-booted. This is not a true
			fault, and does not effect the
			operation of the PV100S. It is
			primarily used as a watchdog for
			debugging purposes.

4–10 152379 Rev C