Xerox 6120 manual Laser Safety, Maintenance Safety, User Safety Summary

The power cord is attached to the printer as a plug-in device at the back of the printer. If it is necessary to disconnect all electrical power from the printer, disconnect the power cord from the electrical outlet.

WARNING!

Do not remove the covers or guards that are fastened with screws unless you are installing optional equipment and are specifically instructed to do so. Power should be OFF when performing these installations. Except for user- installable options, there are no parts that you can maintain or service behind these covers.

" Leave the printer on for optimum performance; it does not pose a safety hazard.

The following are hazards to your safety:

„The power cord is damaged or frayed.

„Liquid is spilled into the printer.

„The printer is exposed to water.

If any of these conditions occur, do the following:

1Turn off the printer immediately.

2Disconnect the power cord from the electrical outlet.

3Call an authorized service representative.

Laser Safety

With specific regard to lasers, this printer complies with laser product performance standards set by governmental, national, and international agencies and is certified as a Class 1 Laser Product. The printer does not emit hazardous light because the beam is totally enclosed during all modes of customer operation and maintenance.

Maintenance Safety

„Do not attempt any maintenance procedure that is not specifically described in the documentation supplied with your printer.

„Do not use aerosol cleaners. The use of supplies that are not approved may cause poor performance and could create a hazardous condition.

„Do not burn any consumables or routine maintenance items. For information on Xerox supplies recycling programs, go to www.xerox.com/ gwa.

152 User Safety Summary