Xerox 6120 Density Request, No/Yes, Cal, Density Black, Control, Transfer, YES/NO Belt, Reset

DENSITY	REQUEST	Settings	NO/YES
CAL	CAL
		If YES is selected, image adjustments are performed.
	MODE	Settings	ON/OFF
		If ON is selected, the image adjustments are applied.
		If OFF is selected, image adjustments are not applied.
DENSITY	BLACK	Settings	1/2/3/4/5
CONTROL
		Adjust the density of the black toner to one of five
		levels.
		If 1 is selected, the density is at its lightest level. If 5
		is selected, the density is at its darkest level.
	CYAN	Settings	1/2/3/4/5
		Adjust the density of the cyan toner to one of five
		levels.
		If 1 is selected, the density is at its lightest level. If 5
		is selected, the density is at its darkest level.
	MAGENTA	Settings	1/2/3/4/5
		Adjust the density of the magenta toner to one of
		five levels.
		If 1 is selected, the density is at its lightest level. If 5
		is selected, the density is at its darkest level.
	YELLOW	Settings	1/2/3/4/5
		Adjust the density of the yellow toner to one of five
		levels.
		If 1 is selected, the density is at its lightest level. If 5
		is selected, the density is at its darkest level.
TRANSFER	Settings	YES/NO
BELT		When YES is selected, the transfer belt counter is
RESET
		reset. Use this setting after you have installed a new
COUNT
		transfer belt.

About the Control Panel 35