Xerox FreeFlow manual Output Bform, Bform parameter options and definitions, Nuvera MX systems

Specifying print format parameters

Table 4-42. Summary of OUTPUT command parameters (Continued)

Parameter	Specifies	Online	Offline	DJDE
OUTPUT STAPLE	Places a wire stitch in copied sets of output.	Y	Y	N
OUTPUT STOCKS	Specifies a STOCKSET for use in the report.	Y	Y	Y
OUTPUT SYSPPR	Specifies the system page paper size for a	Y	Y	N
	job.
OUTPUT TMODE	Specifies a maximum paper width in order to	Y	Y	Y
	improve throughput efficiency when mixed
	paper sizes are used.
	NOTE: This feature is not supported for the
	Nuvera MX systems.
OUTPUT TRANS	Specifies that transparencies are used in the	Y	Y	N
	job.
OUTPUT UNITS	Specifies user selected units for positioning	Y	Y	N
	graphics.
OUTPUT XSHIFT	Shifts the image upward or downward on the	Y	Y	Y
	page.

OUTPUT BFORM

Prints a form on the back side of a duplex data sheet. In association with the duplex printing mode DUPLEX=YES, a page containing only a form (no variable data can be printed with this page) may be printed on the back side of a data sheet. This feature can be used to print static data on the back of each sheet in a report without the use of DJDEs or the repetitive processing of that static data for the back sides of successive sheets.

Syntax OUTPUT BFORM = {NONE (formid [, init [, copies]] [, (INKS, inkref1 [,inkref2] ...)])}

Options

	Table 4-43. BFORM parameter options and definitions
Option	Definition
formid	Specifies the name of the back form – a one to six character form file name
	(may be numeric, alpha, or alphanumeric), which exists on the system disk.
init	initial copy.
	Specifies the first copy set on which the BFORM will be placed.
copies	Specifies the numbers of copy sets that will contain the BFORM.

Using LCDS Print Description Language 4-45