Xerox FreeFlow manual Options 76. Output Sysppr parameter options Definitions

			Specifying print format parameters
OUTPUT STOCKS	• If the stocksetname does not reference a STOCKSET
parameter: points	command coded earlier in the same JDL, the system
to note	assumes that the stockset exists as a .STK file in the “lcds”
	folder, which is read at print time. In this case, XJDC inserts a
	message in the listing file when the JSL is compiled,
	indicating that a .STK file will be used at print time.
	• Whenever a new stockset is chosen at the start of a report or
	through a JDE and JDL switch invoked by a DJDE, the
	system checks each stock to verify that the stock exists and
	can be made active. This verification provides an automatic
	method of changing stocks in the system as required by the
	data stream.
	OUTPUT SYSPPR
	Specifies the paper size for printing pages generated by the
	system (such as error sheets).
Syntax OUTPUT SYSPPR = {USLEGAL A3 A4 B4 USLETTER
	(x, y)}
Options
		Table 4-76. OUTPUT SYSPPR parameter options and
			definitions
		Option	Definition
		USLEGAL	8.5 by 14 inches / 216 by 279 mm
		A3	16.54 by 11.69 inches / 420 by 297 mm
		A4	8.27 by 11.69 inches / 210 by 297 mm
		B4	10.12 by 14.33 inches / 257 by 364 mm
		USLETTER	8.5 by 11 inches / 216 by 279 mm
		(x, y)	User specified width and length.
			• x defines the width in inches, cm, dots, or Xdots.
			• y defines the length in inches, cm. dots, or Xdots.
Default	No default.

Using LCDS Print Description Language 4-83