Xerox FreeFlow manual Graphic Djde options and definitions

Using Dynamic Job Descriptor Entries (DJDEs)

Options

		Table 5-29. GRAPHIC DJDE options and definitions
Option	Definition
name	Identifies the graphic.
	If document interleaved, it becomes the file name with which the .IMG file is
	written.
	If page interleaved, it is used to associate the graphic with other DJDE
	references.
vpos	vertical position.
	Specifies the amount of vertical spacing of the top edge of the graphic from 0,0
	on the physical page.
hpos	horizontal position.
	Specifies the horizontal spacing of the left edge of the graphic from 0,0 on the
	current physical page.
units	Unit of measure for the vertical and horizontal positions of the graphic. The
	following may be used:
	• UN (unit defined by the user)
	•	CM (centimeters)
	•	IN (inches)
	•	DOTS
	• XDOTS (DOTS for 600 spi processing)
	If UN is specified, the user defined positioning unit must be previously defined
	by the OUTPUT UNITS command in the current JDE or JDL.
	The default positioning unit is IN.
H	HOLD
	Specifies that the same graphic is to be held and imaged without further
	callouts at the same position and with the same scale factor at all subsequent
	pages until changed by a DJDE CANCEL or ALTER DJDE.
n/d	numerator/denominator
	Specifies the reference scale factor. Each option, n and d, must be an integer
	in the range of 1 to 8, thereby allowing a reference scale factor in the range of
	1/8 to 8. The reference scale factor is multiplied by the internal scale factor of
	the image.
INKS	Specifies that the ink references that follow will override the inks that were
	defined in the image file.
inkref	ink reference
	Specifies the inks that override the corresponding inks specified in the ink list of
	the image file.

5-40 Using LCDS Print Description Language