Xerox FreeFlow manual Options 75. Output Stocks parameter options and definitions

Specifying print format parameters

Default	NO
OUTPUT STAPLE	• The STAPLE command must be specified in the initial JDL/
parameter: points	JDE, or the JDL/JDE DJDE record must be the first record
to note	processed. If there is a banner page in front of the JDL/JDE
	DJDE record, the STAPLE command is ignored.
	• If the NTO1=YES and STAPLE=YES parameters are
	specified, the system overrides NTO1=YES with NTO1=NO
	and places an error message in the listing file when the JSL
	is compiled.
	• Individual sheets cannot be offset when they are coded in the
	JSL. To maintain consistent face-up orientation while stitched
	and unstitched jobs are delivered to the stacker, you may
	print unstitched sets N-to-1, provided that the system does
	not encounter the override conditions that have been defined.
	• DP 75/90 systems: Jobs greater than 50 pages are not
	stapled. The default behavior is to fault the job, with no error
	message displayed. If you want the job to print without any
	finishing, do the following in the Overprint Finishing section of
	the Finishing window:
	1. Select [Print Job Unfinished].
	2. Select [Check Set–Size] before Printing.
	OUTPUT STOCKS
	Identifies the stockset and its associated stocks that will be used
	for a report. This stockset file (STOCKSETNAME.STK) must
	have been created previously via compilation of a JSL and must
	currently be stored in the “lcds” resource folder.

Syntax OUTPUT STOCKS = stocksetname

Options

Table 4-75. OUTPUT STOCKS parameter options and definitions

	Option		Definition
	stocksetname		Specifies the stockset to be used for the job.
Default		No default.

4-82 Using LCDS Print Description Language