Xerox FreeFlow manual Options 85. PDE Fonts parameter options and definitions

Specifying print format parameters

•The placement of the values of the BEGIN parameter on the FreeFlow Print Server LCDS systems, 4850 LPS, 4890 LPS, and DP92C LPS is relative to the top edge of the physical sheet for all paper sizes. On the 4635 and DP180 LPS, however, an A4 paper size specification causes the image to shift approximately 1/8 inch (3 mm) downward.

If you want to provide consistency between jobs that are printed on the FreeFlow Print Server LCDS systems and on a 4635 or DP180 LPS, you can adjust the alignment by 35 dots using the FreeFlow Print Server LCDS systems queue management windows. Refer to the “Adjusting alignment” section of your printer operator guide for this procedure.

PDE FONTS

Specifies the fonts to be used in printing variable input data and

CME data.

Syntax ac: PDE FONTS = {(f1 [, f2] [,...]) ((f1, s1 [, unit]) [, (f2, s2 [unit])] [, ...])}

Options

Table 4-85. PDE FONTS parameter options and definitions

Option	Definition
f	font.
	Specifies a one to six alphanumeric character identifier (consisting of at least
	one letter) corresponding to a font cataloged on the system disk (you can use
	up to 128 fonts with the font indexing capability).
s	spacing.
	Specifies an optional override line spacing value defined by either the print
	lines per inch (LPI) or the dots per print line (DOTS or XDOTS) to be
	associated with the font. Maximum value for s is 30 LPI; minimum value is 10
	dots.
	There is no default LPI value for s.
unit	A unit of measure for the override line spacing to be associated with a font. The
	unit can be one of the following:
	• LPI (lines per inch)
	• DOTS (dots per print line at 300 dpi)
	• XDOTS (dots per print line at 600 dpi)
	The default unit is LPI.
Default	No default

4-98 Using LCDS Print Description Language