Xerox FreeFlow manual What to do, Default Output Papersize parameter points to note, Uslegal

Specifying print format parameters

What to do:

In order to run the job in succession, you must code the JSL with MOD=5 and POS=1 for Job 1 and MOD=5 and POS=5 for Job 2. The system keeps track of the last tab position in tray 2 at the end of Job 1. Upon starting Job 2, printer purges Tab 3 and Tab 4 because Job 2 starts with POS=5 and Job 1 used Tab 1 and Tab 2.

•You can improve performance by ordering application dependent tab stock. Using ordered tab stock that supports only the number of tabs required for a specific job eliminates the need for purging unused tabs.

OUTPUT PAPERSIZE

Specifies the size of paper that will be used for printing the job.

Syntax OUTPUT PAPERSIZE = {A3 A4 B4 B5 USLEGAL USLETTER (x, y)}

Options

Table 4-68. OUTPUT PAPERSIZE parameter options and definitions

Option	Definition
A3	16.54 by 11.69 inches / 297 by 420 mm
A4	8.27 by 11.69 inches / 287 by 270 mm
B4	10.12 by 14.33 inches / 257 by 364 mm
B5	7.17 by 10.12 inches / 178 by 254 mm (with the 7 by 10 inch enablement kit)
USLEGAL	8.5 by 14 inches / 216 by 356 mm
USLETTER	8.5 by 11 inches / 216 by 279 mm
(x, y)	A user defined paper size; that is, a size that is not one of the standard sizes.
	The x and y variables define the width and length of the nonstandard stock;
	e.g., 7,10 for 7 by 10 inches.

Default

OUTPUT PAPERSIZE parameter: points to note

System default size that was specified at installation

•When centimeters (CM) are used to specify paper size, the maximum allowable value is 32,767 cm.

•Paper size cannot be changed by a DJDE on a page basis. However, paper sizes can be changed on a report basis.

Using LCDS Print Description Language 4-75