Xerox FreeFlow manual Sysppr and the Stockset Syspage parameter

Specifying print format parameters

OUTPUT SYSPPR	• PAPERSIZE=B4 and PAPERSIZE= (10.12, 14.33) produce
parameter: points	identical results in that they indicate long edge feed, as
to note	opposed to short-edge feed format. Refer to the “SEFFNT
	command” section in the “Specifying input parameters”
	chapter for detailed information on short and long-edge feed.
	• The SYSPPR parameter takes effect for the following system
	pages:
	– DJDE error page (OPRINFO parameter of the IDEN
	command)
	– Report delimiter page (PRINT parameter of the RSTACK
	command)
	– Accounting page (ACCT command)
	– Graphic error summary page
	– Short Edge Feed error page
	• SYSPPR and the STOCKSET SYSPAGE parameter:
	System pages are checked for stocks through the SYSPAGE
	parameter. If there is no stock name active for the current
	page, the system checks to see if a stock name was specified
	at the user interface on the Stock tab of the queue Properties
	window. If so, the system page is printed on the stock that is
	specified on the user interface window. If SYSPAGE=stock is
	not specified, the MAIN stock definition is used.
	SYSPPR defines the paper size to use for the system page.
	Therefore, if MAIN contains a mix of USLETTER and
	USLEGAL, the system searches for the appropriate feeder
	tray that contains the required paper size. If SYSPPR is not
	defined, the printer uses the paper size of the current job.
	NOTE: SYSPPR defines a paper size, whereas SYSPAGE
	defines a stock name reference. Both parameters must
	agree in order to prevent errors, similar to the way the FEED
	and PAPERSIZE parameters interact.

4-84 Using LCDS Print Description Language