Xerox FreeFlow manual Options 18. CME Line parameter options and definitions, CME1 CME

Specifying print format parameters

CME INK	• If 0 is specified (or defaulted) for the INK parameter, the ink
parameter: points	for the variable data and the CME text reverts to the ink that
to note	was specified in the IDFAULT parameter of the OUTPUT
	command.
	• An inkindex value greater than the ILIST size causes an “out
	of range” message to be displayed. The operator has the
	option to continue printing the job using black ink or to abort
	the job.
	CME LINE
	Specifies the line range within which the CME is located on the
	page.
Syntax	ac: CME LINE = {n (n, m) (n, –)}

Options

Table 4-18. CME LINE parameter options and definitions

Option Definition

nThe initial line number of the copy modification rectangle

mThe number of lines to repeat the information. If not specified, the information applies only to the starting line.

–A dash character indicates that information is to apply to all lines on a page beginning with the line indicated by n.

Default No default.

CME LINE The line numbers specified in the LINE parameter must always parameter: point be in ascending order. In other words, you cannot specify one

to note line number, then list another one of lower value in the same command. For example, the following command is incorrect and will not be compiled:

CME1: CME	LINE =(2,3), POS=15,
	CONSTANT=(6),’HELLO’, FONTINDEX=3,
	LINE=1, POS=15;

As you can see, the first line parameter specifies starting at line 2, while the second LINE parameter specifies line 1, which contradicts the ascending order.

4-16 Using LCDS Print Description Language