Specifying print format parameters

OUTPUT MODIFY

• A CME may be coded within a JSL or coded and catalogued

parameter: points

separately for use by several JSLs. Any CME invoked by a

to note

DJDE must be catalogued separately. Refer to the “CME

 

command” section earlier in this chapter for further

 

information.

 

• If the CME is within the JSL, it must precede a reference to its

 

identifier by the MODIFY parameter.

 

• Different CMEs may be associated with different copies of a

 

report by the use of multiple MODIFY parameters on the

 

same OUTPUT command. CME copy ranges may not

 

overlap.

 

• If different CMEs are associated with different copies of a

 

report, or if a CME is applied to some but not all copies of a

 

report, then the CMEs are termed copy sensitive. Copy

 

sensitive CMEs may not be used if COLLATE=NO, or online

 

processing is specified. Refer to the MODIFY DJDE section

 

in the “Using Dynamic Job Descriptor Entries (DJDEs)”

 

chapter for a discussion of how CMEs may be changed on a

 

page by page basis within a report ply.

 

OUTPUT NTO1

 

Specifies, on a report basis, whether all copies of a particular

 

report are printed last page to first (n to 1).

Syntax OUTPUT NTO1 = {NO YES n}

Options

Table 4-64. OUTPUT NTO1 parameter options and definitions

Option

Definition

 

 

 

 

YES

Specifies last to first page printing. To print n to 1, output processing must print

 

the report starting with the last page. Therefore, output processing cannot

 

begin until input processing has finished with the entire report. It is possible that

 

input processing does not recognize the end of a report until it detects the start

 

of the next report (header banner page). When YES is specified, the system

 

assumes a 50 sheet threshold for the maximum report size to be printed N to 1.

 

 

NO

Specifies first page to last (1 to n) printing.

 

 

Using LCDS Print Description Language

4-65

Page 305
Image 305
Xerox FreeFlow manual Options 64. Output NTO1 parameter options and definitions