Xerox PE220 manual Installing the Smart Kit, Print Cartridge on, Dialing on, Fuser Area or Around

9 Troubleshooting

Display	Meaning	Suggested Solutions
Memory Full	The memory is full.	Delete unnecessary documents
		and retransmit after more
		memory becomes available.
		Alternatively, split the
		transmission into more than one
		operation.
No Answer	The receiving fax	Try again. Make sure that the
	machine has not	receiving machine is
	answered after several	operational.
	redial attempts.
No Cartridge	The print cartridge is	Install the print cartridge. See
Detected	not installed.	Installing the Smart Kit ®
		Print Cartridge on page 2-4.
Not Assigned	The speed dial location	Dial the number manually using
	you tried to use has no	the number keypad or assign
	number assigned to it.	the number. For storing a
		number, see Automatic
	The ID you entered is	Dialing on page 7-14.
		Enter the correct ID. .
	not assigned.
No Paper	The paper in the tray	Load paper in the tray. See
Add Paper	has run out.	Loading Paper on page 2-6.
Operation	You are doing the Add/	Check the display to see if there
Not Assigned	Cancel operation, but	are any scheduled jobs. The
	there are no jobs	display should indicate them in
	waiting.	Standby mode; for example,
		Delay Fax.
Out of Range	The current date and	Enter the correct date and time.
	time you entered is not
	correct.
Open Front Door	Paper has jammed in	Clear the jam. See In the Tray
Remove Paper	the feeding area of the	on page 9-4.
	tray	Clear the jam. See In the
	Paper has jammed in	Fuser Area or Around the
	the fuser area or around	Print Cartridge on page 9-5.
	the print cartridge.
Open Rear Cover	Paper has jammed in	Clear the jam. See In the
Remove paper	the paper exit area.	Paper Exit Area. on page 9-
		6.
Power Failure	Power has turned off	The job which you were trying to
	then on and the	do before the power failure
	machine’s memory has	must be completely re-done.
	not been saved.

9-10 Xerox PE220