Zebra Technologies 3ULQWHUV manual 8QSDFNDQG,QVSHFWWKH3ULQWHU, 7R5HSRUWDPDJH, 6WRUDJH

Introduction

Unpack and Inspect the Printer

8QSDFN￿DQG￿,QVSHFW￿WKH￿3ULQWHU

Make sure the printer is in good condition when you receive it. The instructions below outline what you need to do.

,QVSHFW￿WKH￿3ULQWHU￿

Use this list as a guide to inspect the printer.

‡Check all exterior surfaces.

‡Raise the media access door and inspect the media compartment.

‡In case shipping is required, save the carton and all packing material. Contact your authorized Zebra reseller for instructions.

‡A power cord may or may not be included. If one is not included, or if the one included is not suitable for your requirements, see Power Cord on page 7.

Caution • For personal and equipment safety, always use an approved three- conductor power cord specific to the region or country intended for installation. This cord must utilize and IEC-320 female connector, and the appropriate region- specific three-conductor grounded plug configuration.

7R￿5HSRUW￿'DPDJH

If you discover shipping damage:

‡Immediately notify the shipping company and file a damage report with them. Zebra Technologies is not responsible for any damage incurred during shipment of the equipment and will not repair this damage under warranty.

‡Keep the carton and all packing material for inspection.

‡Notify your authorized Zebra reseller.

6WRUDJH

If you are not placing the printer into operation immediately, repackage it using the original packing materials. The printer may be stored under the following conditions:

‡Temperature: –40° to 140° F (–40° to 60° C)

‡Relative humidity: 5% to 85% non-condensing

2 Zebra XiIIIPlus Users Guide