![](/images/new-backgrounds/1266153/26615381x1.webp)
Printer Setup and Calibration
Before You Begin
7RDGMXVWWKHXSSHUDQGORZHUPHGLDVHQVRUVFRPSOHWHWKHVH
VWHSV
1.Remove the ribbon (if ribbon is used).
2.Locate the upper media sensor. The upper media sensor eye is directly below the adjustment screw head.
See the illustration for a simplified view of the media sensor. Callouts in the illustration are explained in the table that follows.
| 1 |
| 2 |
&DOORXW | 'HVFULSWLRQ |
Upper media sensor adjustment screw
Upper media sensor
Note • If you are using continuous media, position the upper media sensor over the labels so that the printer can detect an
3.Slightly loosen the upper media sensor adjustment screw (use a
4.Using the tip of the screwdriver, slide the upper sensor along the slot to the desired position.
5.Tighten the adjustment screw to secure the upper media sensor.
Zebra XiIIIPlus Users Guide | 21 |