Zebra Technologies 3ULQWHUV manual Setting the Head Resistor Value, Default Value

Appendixes

Front Panel Controls

3UHVV	/&'	'HVFULSWLRQ
		Setting the Head Resistor Value:
		Caution • Do not set the value higher than that
		shown on the printhead. Setting a higher value may
		damage the printhead.
	+($'￿	1. Press the left black oval to move to the next digit
		position.
	5(6,6725￿
		2. Press the right black oval to increase the value of
		the digit.
		Caution • This parameter should be changed only
		by qualified service personnel.
		Initial Value: Factory-set to match the printhead
		shipped with your printer.
		Default Value: 0500
		Range: 0500–1175
		This value has been preset at the factory to match the
		resistance value of the printhead. It does not need to
		be changed unless the printhead is replaced or the
		main logic board is replaced.
		Before replacing a printhead, look on the printhead
		for the label that shows the resistance value (ohm
		value).

Zebra XiIIIPlus Users Guide 81