Labels and Print Modes

Print Mode Choices

&DOORXW 'HVFULSWLRQ

￿Media supply guide

￿Labels

￿Guide plate

￿Spindle hook

￿Rewind spindle

￿Rewind plate

3HHO￿2II￿0RGH￿

Peel-Off Mode advances one label at a time. The printer does not print another label until the first label is removed. The TAKE LABEL light flashes until the label is removed. The liner is wound on the rewind spindle, but the rewind plate is not used.

7R￿VHW￿XS￿WKH￿SULQWHU￿LQ￿3HHO￿2II￿0RGH￿￿FRPSOHWH￿WKHVH￿VWHSV￿

1.Remove the rewind plate (if installed) from the front of the printer. Store it on the two mounting screws on the inside of the front panel.

2.Open the printhead.

3.Slide the media guide and media supply guide as far from the printer frame as possible. Flip down the media supply guide.

4.Start by loading labels as shown in Load the Printer on page 10.

5.When loading labels, allow approximately 36 in. (915 mm) of labels to extend past the tear-off/peel-off bar. Remove all labels from this portion to create a leader.

6.Remove the hook from the rewind spindle. If you are using a core, slide it onto the rewind spindle until it is flush against the guide plate.

7.Wind the label liner around either the 3 in. (76 mm) core or the rewind spindle and reinstall the hook.

8.Flip up the media supply guide. Slide in the media guide and media supply guide so they just touch, the edge of the labels. The labels should lie flat.

9.Before closing the printhead, make sure:

The labels are positioned against the inside guides.

The labels are taut and parallel with the pathway when wound onto the rewind spindle or core.

Zebra XiIIIPlus Users Guide

29

Page 49
Image 49
Zebra Technologies 3ULQWHUV manual 3HHO2II0RGH, Doorxw Hvfulswlrq