11
USB INSTANT DVD INSTALLATION
2. Wire It Up! (cont’d)2. Connect your USB Instant DVD
Audio to the Sound Card on your PC.
This will send Audio from your USB
Instant DVD to your PC.
3. Connect your USB Instant DVD to
your TV or VCR. This will send cap-
tured or edited video back to your TV
or VCR for viewing or recording.
Connect (G) RCA cable to “Video
Out” on Instant DVD
Connect other end to Video IN on your
TV or VCR.
Connect one end of your (E) 6 ft.
male to male stereo audio cable
to the Audio Out jack at the back of
your USB Instant DVD.
Connect the other end to the Line In
jack on your sound card of your PC.
Check your diagram of connectors on
your Sound Card
USB Instant DVD
USB Instant DVD
A/V Source
PC Sound Card
Check Contents - Wire it Up! - Plug it In! - Install Optimize System- - Verify Installation - Set Audio Mixer - Installation Summary
If you want to send captured or edited video
back to your TV or VCR for viewing or recording,
continue steps 3 & 4. If you only want to preview
& capture the video on your PC, skip to the Plug
It In section on page 6.
CapWiz manual.p65 6/4/2002, 12:21 PM11