Chapter 10: File Downloads and Uploads
188 Section II: Advanced Operations
The System Utilities menu is shown in Figure 6 on page 43.
4. From the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 54 on page
170.
5. From the Downloads and Uploads menu, type 3 to select Download a
File.
The following prompt is displayed:
Only TFTP downloads are available for a Telnet access
TFTP Server IP address:
6. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
7. Enter the name of the file on the TFTP server you want to download
into the switch’s file system.
The following prompt is displayed:
Local File Name:
8. Enter a name for the system file. This is the name that the switch will
store the file as in its file system. To store the file on a flash memory
card in the switch rather than the file system, precede the name with
“cflash:”.
The following message is displayed:
Getting the file from Remote TFTP Server - Please wait
...
9. If you have not already done so, start the TFTP server software.
After the switch has downloaded the system file, the following
message is displayed:
File received successfully!
10. If you downloaded a configuration file and want to make it the active
boot file on the switch, refer to “Setting the Active Boot Configuration
File” on page 149. If you downloaded a CA certificate, refer to “Adding
a Certificate to the Database” on page 616.