Chapter 21: SNMPv3
356 Section IV: SNMPv3
Configuring the SNMPv3 SecurityToGroup Table
This section contains a description of the SNMPv3 SecurityToGroup Table
and how to create, delete, and modify table entries. The SNMPv3
SecurityToGroup Table allows you to associate a User Name with a
Group Name. The User Name is configured in the Configure SNMPv3
User Table menu while the Group Name is configured in the Configure
SNMPv3 Access Table menu. In addition, the configuration in the
Configure SNMPv3 Access Table menu defines which MIB views this
User can read, write (modify), and send traps from. For each User Name,
you can assign:
A Security Model (SNMPv1, SNMPv2c, SNMPv3)
A Group Name
A Storage Type
There are three functions you can perform with the SNMPv3 Access
Table.
“Creating an SNMPv3 SecurityToGroup Table Entry,” next
“Deleting an SNMPv3 SecurityToGroup Table Entry” on page 359
“Modifying an SNMPv3 SecurityToGroup Table Entry” on page 360

Creating an

SNMPv3
SecurityToGroup
Table Entry
To create an entry in the SecurityToGroup Table, perform the following
procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 5 to select Configure
SNMPv3 SecurityToGroup Table.