Chapter 21: SNMPv3
366 Section IV: SNMPv3
I-Inform
Indicates this notify table is used to send inform messages. With this
message type, the switch expects a response from the host.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
7. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 Notify Table to the configuration file. After making
changes to an SNMPv3 Notify Table entry with a Volatile storage type,
the
S - Save Configuration Changes option does not appear on the Main
Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Notify Table to the configuration file. After making changes to
an SNMPv3 Notify Table entry with a NonVolatile storage type, the S -
Save Configuration Changes option appears on the Main Menu,
allowing you to save your changes. Allied Telesis recommends this
storage type.
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 Notify Table entry takes effect immediately.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 Notify
Table Entry
You may want to delete an entry from the Configure SNMPv3 Notify Table
menu. When you delete a Configure SNMPv3 Notify Table entry, there is
no way to undelete, or recover, the entry.
To delete an entry in the Configure SNMPv3 Notify Table menu, perform
the following procedure:
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 6 to select Configure
SNMPv3 Notify Table.